Can any one tell me what the two small "squares" are for on the front-end, near the ground... what kind of lights?

If you are talking about those two tall and thin rectangles that are recessed into the front end, they are fake brake-cooling ducts. I feel that they are the worst part of the xB design.

i am hoping someone will make some LED for/accent lights to take up those openings...say two columns of lights with like 15 rows going down on each side, I think it would look great.

If you are talking about those two square inserts in the bumper (painted body color, about 1.5X1.5), they are covers for the tow/pull points. There is a special tool for pulling them out, and an eye bolt that you screw into the hole underneath. I was wondering that too until I saw it in the manual.

i am hoping someone will make some LED for/accent lights to take up those openings...say two columns of lights with like 15 rows going down on each side, I think it would look great.



Photo shop Please so we can get a visiual.

Row=horizontal=2
Column=vertical=15 (approximate)
2X15

Use your built in PS. Some people refer to it as an imagination.

Saw a photo where someone installed fog lights there. ... lights about the size of the holes. thanks for replies.

Picture please

I HATE non-functional duct openings.

Hope someone (Toyota?) will manufacture modification kit to turn '08 xB'sFAKE brake-cooling ducts into FUNCTIONAL ducts. All it would need is removal of fake blanking panels, then add ducts to new fender-liner holes pointing at brake disks.

On my old '86 VW GTI 8v, VW offered a replacement chin spoiler from '87 16v. After I nstalled the new spoiler, VW sold me their plastic ducts that cut into the fender liners.

SEARCH

fake break-cooling ducts. Nothing out yet to make them functional/look better

someone should put some LED lights there..that would look sic