Just bought the strup combo header/exhaust along with the silencer and new gasket just in case. I have some questions :eyebrow: . Should I ceramic coat the header? People said on here that they relocate the shifter cables to prevent any meltage. Also people had some troubles with the exhaust being centered due to the hanger i believe. How would I go about bending it, or should I have a shop do it?




THAAAAAAANKS

Just bought the strup combo header/exhaust along with the silencer and new gasket just in case. I have some questions :eyebrow: . Should I ceramic coat the header? People said on here that they relocate the shifter cables to prevent any meltage. Also people had some troubles with the exhaust being centered due to the hanger i believe. How would I go about bending it, or should I have a shop do it?




THAAAAAAANKS
you can wrap the header, its cheaper, but not as good of a solution.

yeah I was thinking about just wrapping them but lots of people don't recommend it because it destroys the header super-duper x3 fast. I seen spray cans that are meant for headers and exhausts but I'm not sure if it is just as bad as wraps. The strup is stainless steel i think.