New Custom catback. Pics and Vids!
#1
New Custom catback. Pics and Vids!
I got tired of waiting for an exhaust system to comeout for the 2nd gen so,... I got a carbon fiber universal muffler and did a custom-bolt on catback system from a muffler shop.
Since it's carbon fiber, i made it angled a little. I have Tanabe DF springs so i'm little on the low side. So far, I've been careful with the bumps and dips so i havent had any scrapes.
The sound is amazing. Not loud at all since I bolted on after the resonator. It's very deep and has minimal drone during high speed cruise.
Feel free to ask me questions!
Since it's carbon fiber, i made it angled a little. I have Tanabe DF springs so i'm little on the low side. So far, I've been careful with the bumps and dips so i havent had any scrapes.
The sound is amazing. Not loud at all since I bolted on after the resonator. It's very deep and has minimal drone during high speed cruise.
Feel free to ask me questions!
#4
man this is exactly what i want!!! anyway you can get them to make you another one of those pipes and send it to me? how much did it cost? i have access to a welder...just need that axle back piece... damn! oh and where is the can from? can you take a pic of the whole car from the rear...i would like to get a sense of proportion of the can to the car...
thanks!
thanks!
#7
cincinfocal - I got the universal muffler from a local seller and did it custom. I'll take more pics later with a better scenery tomorrow and post it online. where are you located?
onemorescion - The muffler came with that bracket. The muffler shop welded the hangers onto the bracket
onemorescion - The muffler came with that bracket. The muffler shop welded the hangers onto the bracket
Thread
Thread Starter
Forum
Replies
Last Post
xa007xa
PPC: Engine / Drivetrain
0
03-31-2015 09:24 PM
gyiu
Regional - Pacific South
12
02-20-2015 04:20 PM
CONCRETETC
PPC: Interior / Electronics
1
02-09-2015 08:05 PM