i know that someone posted how to tweak the TC alarm sensitivety, but i cant find it. basically just need to know how to take out the glove box so i can get to the setting in the back. thanx everyone

 

shiza..it was in tech I think....basically I guess the two clips under the glove box that gives it a "stopping point" when the glovebox it totally open....they need to be removed or displaced...then u can reach back there.

 

The glove box requires no tools to pull out... open it, and from the Left side, youll see a stopper, the point is to push the plastic on the side enough for the stopper to slide out... when its out, hold it there, then do the Right side... then on Right side again, underneath where the stopper is, just unclip the little hydraulic... then itll open wide... still held by clips at the bottom, just tug at the glove box until it comes off... thats it, youre done

 

there is also a piston attached to the right side of the box. it just pops off by pressing in on the center pins.

it's essentially a gear with an arm that slows the glove box so when you open it it doesn't just fall down real quick.

 

^ oh, thats what I meant by "little hydraulic"