if i trim my RS1 lip to fit my OEM grill, will it also fit the VRD grill? i know the VRD has the "3d" look. i have my RS1 lip and wanna get it painted, but i haven't gotten in my VRD grill yet.

 

what do u mean trim it it should fit fine so should the VRD

 

my lower vrd grille doesn't fit with the RS1 lip. Definitely needs to be trimmed but I'm too chicken to do it.

 

it should fit right in

 

^dunno why mine's different. On the bottom, the lip is in the way and I cannot push the grille all the way in for the tabs to fit...if that makes sense?

 

yeah thats what i've heard.....i've been told the u have to trim the RS1 lip to fit even the OEM grill. my question though, is if i trim the RS1 to fit the OEM grill, will it fit with the VRD grill

 

the bottom of the lip u have to trim until the line of the grill. thats all.

 

any grille you get (besides 0 must be trimmed

 

It seems like the RS1 lip is basically made to fit that bottom part where the grill goes in, exactly to the edge rather than 1/4inch or so shy so the grill has some room to clip in.

Can't really explain it, but my VRD bottom grill won't fit perfect with my RS1 lip either and like ilovemytC i'm too afraid to trim it.

I've already trimmed CF and it is UGLY. The resin chips off leaving the CF exposed and jagged. It would need to be done with a dremel & tape over the lip where you want to trim but again i'm too wuss.

My bottom grill clips in all up top still and on the sides but not the very bottom, but I don't mind it's not noticable and the grill is still set in real well.

 

so basically, since my lip isn't carbon fiber, it shouldn't be a problem to trim it them right? its not painted yet or anything

 

yeah itll be fine

 

it should fit right in

 

Corina we had the same thibg happen this weekend duribg an install.....trim th bottom edge of the VRD grill......i will show you on saturday what to trim........

 

trim it back bout a 1/4" more just to be safe. it has plenty to go anyways.