I just got some wheels and was wondering what type of Wheel Locks to get?

Are the xBs thread size pretty generic?

I know there are 2 types. One with the keyway on the outside and one in the center.
I did not want it to stick out like a sore thumb either. Anyone know of a type that blends in more with the stock type lugs?
Also where to get them..

Thanks

The ones by Gorilla have done me well for the last 5 years.

Key lock on the outside is much better then the center inset ones tend to strip out if you dont seat down right.

12×1.5 Lug nut, most likely conical seat on your wheels. (12 refers to 12mm diameter of the factory lug stud and 1.5 is the thread pitch)

12×1.5 Lug nut, most likely conical seat on your wheels. (12 refers to 12mm diameter of the factory lug stud and 1.5 is the thread pitch)

Cool....got it... thanks.

Does anyone know where to get gorilla?

americas tire company locations in torrance, and carson carry them, as well as their own brand of wheel locks - which are just as good imho and only $1.50- each :)

americas tire company locations in torrance, and carson carry them, as well as their own brand of wheel locks - which are just as good imho and only $1.50- each :)

HEHE cool thanks!!! I know one in San Pedro too..

Thank again.

I need to put wheel locks today. I might get 2 sets, 2 per wheel.

americas tire company locations in torrance, and carson carry them, as well as their own brand of wheel locks - which are just as good imho and only $1.50- each :)

Thanks Besk One..

I went to American Tire Co in San Pedro.
I picked up Gorilla Locks for $20

My stock xB lug removal bar does not fir the Gorilla key.
Luckily i thought about it before i left there.
I went back inside and bought a Gorilla Bar.
Its sweet. It telescopes and has a rubber grip. Only $20.

Also thanks Kendo for the post on lug size. It was 100% right...

so, if i go to ebay to buy the wheel lock, the size should be 12x1.5 right?