sp2

so i was looking up stuff on the TC yesterday and noticed that Ptuning has a full header back or after spipe 3" turbo back exhaust system.

(after s-pipe back)
http://www.ptuning.com/html/Item-Des...o&ModelDesc=tC

(header back includes spipe)
http://www.ptuning.com/html/Item-Des...o&ModelDesc=tC

I know alot of ppl have bein wanting something to replace that fat resonator/cat to get a little more sound out of the XB2.
well so i emailed the guys at ptuning asking if they planed on making a set up like that for the xb2

reply...
"Hello,

We designed and produced the 3" turbo-back system for the tC because of the
high demand.
If we have the same high demand for the 2008+ xB exhaust, we definitely
would consider producing one.
If we can get commitments from 50+ customers, we can start prototyping."


so reason for this post
was going to try and see if there is a demand for it

so if you would really be interested in a set up like this
vote and reply
please

miketf1

it would be great to have this kit but i would like it to just go right up to the axle that way we have the option to go with hks, trd, tanabe, etc tips as opposed to just tip that is provided. it may provide a slight amount of backpressure for those with the TRD but its so far down from the flow that it would make minimal difference

boooosty

make it!

DAILYXB-TYPE-R

i'll be watching

XD40tC

3 inch? No thanks. Id much rather have them make me an exhaust that was less than 2.5 inches NA wise. Not to be mean or anything but you arent going to find the demand any time soon if at all. Good luck though! Ptuning is an Excellent company!

sp2

Yea well i know not going to be that big of demand for 3'' so if enough ppl would be interested in a like 2.25'' or 2.5'' replacement center from spipe to axle and leave some love that they would want it i can show ptuning the demand and they might make something

tainoxl

2.5 spipe back would be your best bet.

XD40tC

I would be interested in a 2.25'' setup.

CarbonXe

iTrader: (1)

I have the turbo-back for my tC and I will say, that you will not see any other exhaust come even close to the quality of the PTuning exhaust. Perfect welds, high grade stainless steel, thick ___ Vband clamps (someone said they were about $80 a piece).

ShaffNasty

I vote 2.5 with different options like s-pipe to axel only...

redline8k

I vote for either a 2.25 or a 2.5 with options for single or dual exits....
-nick

sp2

ok everyone ima create a new topic about this be sure to vote over there
because if you guys dont vote then i dont have proof to show ptuning about the demand for such a product

DREWxB08

iTrader: (1)

I 2nd that.

MurderBox

N/A mid pipe is a great idea.