so here's the story, i went to an aftermarket shop here in california and bought a Universal "TSUDO CARBON TI" exhaust... right after, i went to the nearest muffler shop to get a quote. The guy ended up telling me that it would cost me $200+ and he would have to angle it a lot because if he were to put it straight, he would have to do piping between the rear axel and camber arm but then again it would get squished since im lowered on s-techs, right? AND the exhaust canister was too long so it would either hit the rear axel or it would stick out the end like 3 inches or so.

i HATE ANGLED exhausts! i sold my hi-power because of the annoying angle.

so, heres the question...

i want the black universal APEXi N1 exhaust, would that fit if i wanted it straight? and how would i do the piping...

PLS HELP...

 

err...it doesnt have to be angled. you just wont get the most "efficient" flow. the piping can just follow the OEM pipes around the rear section. itll look similar to the "axel-back" part on the injen exhaust or greddy evo 2 exhaust. it wont get squished if youre lowered...unless you drive over speed bumps at like 50 mph >_> should be ok if you just be careful and drive sensibly