I love my new Borla
Yesterday I received my exhaust from TRD Sparks. It is completely different from what is seen on the Borla website. The muffler is inline vs the side by side inlet and outlet. This morning I installed it in about 20 minutes. The biggest pain was removing the stock exhaust, mainly the rubber hangers were tricky. I love the sound, and couldn't be happier..
Check it out...
http://www.youtube.com/watch?v=7FHsJGxJ4KA
Check it out...
http://www.youtube.com/watch?v=7FHsJGxJ4KA
yea the header will make the exhasut louder and raspy..cause it deletes the cat..if you have a custom midpipe or sometime then il be even louder cause no cats mean loud and raspy but you can get big resonators to help most people do that
Originally Posted by cdeeznutz
that sounds hella good!! is this the exact same as the TRD axelback exhaust?
http://www.trdsparks.com/displaypart...2&parts_id=644
I'm not sure, but I think they build their own system. Check out what the Borla website has to offer. http://www.borla.com/applications/lo...Section/11743/
As you can see they look and are built completly different. I choose the TRD Sparks because it was cheaper, and the muffler was inline.
I heard that TRD exhaust was made by Borla. Maybe TRD just uses a Borla muffler... Not that sure..
It is definitely a nice exhaust for those not looking to gain too much unnecessary attention. I have had this exhaust from day one (dealer add on) and have love it. The only thing I would change is the mid-pipe. I am currently looking into the Megan mid to create more of a deeper tone. Not louder, but just a touch deeper.
Thread
Thread Starter
Forum
Replies
Last Post
EV_AIC-xB
Scion xA/xB 1st-Gen Drivetrain & Power
11
Oct 15, 2003 11:57 PM
EV_AIC-xB
Scion xA/xB 1st-Gen Drivetrain & Power
11
Oct 10, 2003 07:28 AM






