Where can i find the injen axleback exhaust right now?



also, it doesnt take any low end power away right?

Where can i find the injen axleback exhaust right now?



also, it doesnt take any low end power away right?

http://www.RacingSolution.com ... I haven't seen the dyno runs but it should only increase both horsepower and torque, even on an N/A motor

you can also find it on trdsparks.com

Where can i find the injen axleback exhaust right now?



also, it doesnt take any low end power away right?

http://www.RacingSolution.com ... I haven't seen the dyno runs but it should only increase both horsepower and torque, even on an N/A motor

What size can is that? a 5 inch round or 6 inch?

Where can i find the injen axleback exhaust right now?



also, it doesnt take any low end power away right?

Here's the link to our exhaust page and we've been told that the HP increase is 6 to 8. We just dropped the price on this exhaust.

http://www.trdsparks.com/displayparts.php?Mdl_dtl=447&Part_cat=2&parts_id=588

Ken
www.trdsparks.com

one last question before i purchase the injen exhaust......... is it possible to install it yourself without having to lift the car up at all? Do you just unbolt the rear section thats on there now and put on the injen or what?

It is possible to do yourself, but I'm hearing that you may want to lift it some to make it easier. I would personally want a bit of lift.

Ken

Where can i find the injen axleback exhaust right now?



also, it doesnt take any low end power away right?

Here's the link to our exhaust page and we've been told that the HP increase is 6 to 8. We just dropped the price on this exhaust.

http://www.trdsparks.com/displayparts.php?Mdl_dtl=447&Part_cat=2&parts_id=588

Ken
www.trdsparks.com

from my dyno it appears to be 5hp 4tq not bad. Thats with out an intake.

kewl, thanks

That's probably right and add in the filter that comes with it and you should see 6.

Ken

for ppl who have it.. hows the sound and how is compared to the other axle backs?? (like borla and TRD)

thanks

wow 5hp out of an axlebak? im convinced but how about warranty issues, what would be voided?

installed my injen axelback a few days ago...... SOUNDS GREAT!!!! also, im pretty sure adding that alone will have no effect on the warranty

There is no way a quality axleback can damage anything .All the clamps and the design are well thought out remember they have to prove that the part you installed caused something to go bad. Also they must provide written proof of this , an axleback will not cause any damage to any part of the drivetrain if properly installed.

i just installed min today and ive been out with my friends from around 6:30pm when i got this done till now 1:30am and it sounds good untill your going 50mph or above the exhaust is realy loud. a good loud but still loud. i like it and i should have pics up on my cardomain some time this week it took me about 25 min. to install it. the only thing i realy didnt like abou the install was that i had to go buy new nuts for the injen exhaust becouse the factory nuts are welded to the flange and the injen didnt come with any (or i couldnt find them in the over sized box full of paper) other then that it was easy and well worth the cash but be know when you go to order it it's realy loud

mine came with some stainless bolts. Thats wierd that yours didnt. In my case however it didnt come with instructions. Hey does your imjen rub up against the optional bodykit? i know mine does. Well besides that minor issue i love the injen unit it sounds great especially when the tranny downshifts. Sounds deep throaty nothing like that drexas unit lol. Oh and i got 5hp and 4tq out of it. with out intake.

mine has about a 1/4 of a cm gap between the stock bumper and the tip but its alright i guess

yea, i had to go get some new bolts also

did any one get locking nuts i was thinking about it but i have had problems with them destroying bolts (when over tightend) before so i went with reguler nuts

anyone have a soundclip of the injen exhaust. or if its been posted already a link to page where it does

^
db test
http://www.injen.com/new_layout/testing/db_test/scion_tc_dbtest.AVI

here is volcom85's cardomain page he has a clip there
http://www.cardomain.com/memberpage/672070

Thanks for the links aaron couldn't get the cardomain one to work but sounds good other wise. I think this is the one im gonna get.

How much will it cost to get this installed?

i say install it yourself. can't be that hard. i think i'm gonna get this too once i find the best price shipped to HI.

install yourself!!!, i did it without lifting the car, and only took about 15 mins, not including the time to go buy new nuts. all you have to do is unscrew the 2 bolts and remove the rear section from the hangars, then replace it with the injen and put the bolts on, quick and easy

i did it easy to but it was a little hard getting under the car since im fat and my car has the trd coils

ok well if any one has pics of the actuall installation that would be very helpful. but basically all there is to it is unscrewing a few bolts?

ok well if any one has pics of the actuall installation that would be very helpful. but basically all there is to it is unscrewing a few bolts?

I parked the car on a double sidewalk gave me a gap in the middle of about 2 feet for me to work under the car, safest route no lifting. Let the car cool down did it in about 30 min. All you need is 2 pairs or 1 of flat head screwdrivers , WD 40: very important with out it it will be tough to remove the rubber holders from the muffler hanger, spray the wd 40 on the rubber holders and hangers spray plenty, then lift up the edge of rubber hanger with screwdriver and spray some in the exposed area, do that to all hangers and rubber holders, this will make them slip out much quicker. Also a properly sized wrench will be needed and thats it very easy stuff and it gives you a great view of the independent suspension :)

ok well if any one has pics of the actuall installation that would be very helpful. but basically all there is to it is unscrewing a few bolts?

I parked the car on a double sidewalk gave me a gap in the middle of about 2 feet for me to work under the car, safest route no lifting. Let the car cool down did it in about 30 min. All you need is 2 pairs or 1 of flat head screwdrivers , WD 40: very important with out it it will be tough to remove the rubber holders from the muffler hanger, spray the wd 40 on the rubber holders and hangers spray plenty, then lift up the edge of rubber hangar with screwdriver and spray some in the exposed area, do that to all hangars and rubber holders, this will make them slip out much quicker. Also properly sised wrench and thats it very easy stuff and it gives you a great view of the independent suspension :)

exaclty what he said. all it takes is looking at the rear section under the car for you to see how easy it is to replace

acasanova- You said yours rubs against the groundeffects. Is this causing any problems melting, black marks, etc.??

^not for me and i have put about 400 miles on my car since i got the exhast on friday

cool did you order yours from TRD Sparks or do you know a cheaper place?

acasanova- You said yours rubs against the groundeffects. Is this causing any problems melting, black marks, etc.??

no melting apparently the tip dosent get hot enough to melt the rear bumper. There is a small black mark the paint did burn off . However its very small and cant be seen im going to try to remove then refit the muffler see if that helps.

i got mine from my local shop http://www.speedwayperformance-inc.com/ it cost a little more for me it was 360 i think but i just picked it up and through it on once it got in

Hey aarontrini85, can you please post a sound clip, and not the one with the decible test, just normal driving, and hard accleration. Thankyou

the cardomain site has a just average driving clip on it. Page 1 of this thread.

the cardomain site has a just average driving clip on it. Page 1 of this thread.

i heard it ,sound like crap to me, i have the injen unit and for some reason it sounds nothing like the cardomain demo.

oh really... whats the difference in sound?

mutch deeper and a hell of alot louder but i like it when i heared the cardomain link i didnt want it but now that i have it i love it

it did have to grow on me though at first i thought it was to loud but it either quited down now that it is breaking in or i got used to it or both

ive had the injen for a little while, i just installed the weapon r today........ still sounds GREAT, you can hear the intake around 3k+ rmps,

PEOPLE come on instead of saying how it sounds or saying it sounds good just post up sum clips for the rest of us...
plzz?

id love to but i have no type of recording devices lol

They wouldn't give me any dyno numbers but I'm told to expect gains in the 6-8 range, with a "throaty but subdued" sound.

http://www.borla.com/applications/lookup.aspx/2005/Scion/tC/Rear_Section/11743/

Anyone hear anything about this setup? :doh:

They wouldn't give me any dyno numbers but I'm told to expect gains in the 6-8 range, with a "throaty but subdued" sound.

http://www.borla.com/applications/lookup.aspx/2005/Scion/tC/Rear_Section/11743/

Anyone hear anything about this setup? :doh:
wow that doesnt help at all man, every aftemarket exhaust sounds "throaty" and i dont want subdued i want hella formula 1 loud

They wouldn't give me any dyno numbers but I'm told to expect gains in the 6-8 range, with a "throaty but subdued" sound.

http://www.borla.com/applications/lookup.aspx/2005/Scion/tC/Rear_Section/11743/

Anyone hear anything about this setup? :doh:

ill see if i can find my camera tomorrow

We have added this item to our inventory at this time as well as our full line of exhaust kits.

CreativeCompacts.Com

guys im gonna make a recording today. Stay tuned.

ill get some videos to i just found out my sony cyber-shot digital camera can do video so ill try and get them up in about 20-30 min does any one have a site i can upload to?

ok i have one of the videos done but i cant upload it to my geocities page becouse it is to large its around 8mb if any one can host it for me that would be great if not im trying to get a hold of my dad so i can use comcast's web space to host it i just need his username and password

does anyone else have the exhaust with the dc headers? because i do and its really loud and not what i expected. i like it but wish it was deeper. i didnt get any bolts in mine either. i had to work on it in the parking lot of autozone. but didnt take long. www.i-m-racing.com has some and i also got free shipping for $350.

my video is up on my cardomain page now check my sig. i did it with a digital camera so it is sort of quite if you turn the volume up on your speakers alot then it will sound like it normaly does ill try and get another one on my drive to work

love the cardomain audio clip you just made, it gives the exhaust its rightful place . It sounds like that on my car. Nice and deep unlike what some of the tards here on this forums say its sounds like.

thank you im also going to do a proper smoking of the tires when i take my lunch at 6pm central time so if you want to see that it will be up by 7pm

sounds ok, did you do anything to make it louder, or just bolt on the axleback?

just the axle back im still shoping for a header and im waiting for my intake

its really loud with the headers...it kind of gives it a high pitch and kinda of scares me that it sounds ricey at times but no one else has said so. maybe just me, but im gonna get the intake soon and then be done with power mods for a while and start saving up for a turbo kit. oh yea and where do u get the soundclip...i couldnt find it?

its at the top of my cardomain page