Is there anything special i should know about removing the auto shift ****? Or is it just those 2 screws that are in the front? Thanks

 

I think there is more than those 2 screws, but i am not sure, mine broke off and i havn't been able to replace it yet. I hope somone knows because this would help me out greatly as well. Also is there an automatic **** that is aftermarket with the traction control on it????

 

I dont know man. The reason why i wanna take it off is to run some wires through the center console.

 

through the console? You shouldn't have to take of the shifter for that. All you need to do is take our the one screw in the back cup holder and the whole middle console should come off. i dunno if that helps or not but i hope so.

 

yeah, i was analyzing it today and i noticed that I didnt have to remove it. Sorry bout that I guess I jumped the gun, lol. If you would like to close the thread its alright.

 

hey Appe , what's up man its SPOONfdEK from JDMU, you dont need to remove the shifter . just remove the screw under the small peice of rug in the cup holder , i wanted to take mine off and see if i could make it shorter

 

Yeah thanks. I already installed the cold cathode kit. Thanks for all the advise.