So using the TRDs we self lowered the springs. RSmiller1 and I spent a whole 4-5 hours doing it because we had never done it before and painted/worked on a MR2 as well. THe last shot is front and rear done. the dirty ones are just rear


http://farm3.static.flickr.com/2538/5778358563_2bcc99efbb.jpg
http://farm3.static.flickr.com/2693/5778351201_c69536c010.jpg
http://farm4.static.flickr.com/3576/5778892532_5275b6bf21.jpg
http://farm4.static.flickr.com/3503/5778356111_1ecc75d3b2.jpg
http://farm3.static.flickr.com/2394/5778904744_ffba4acc53.jpg
http://farm3.static.flickr.com/2299/5778907300_1d9352d239.jpg
http://farm3.static.flickr.com/2097/5778366079_74855cbfc6.jpg
http://farm4.static.flickr.com/3086/5778368671_c9bdfe9754.jpg
http://farm3.static.flickr.com/2731/5778371095_4ec6e3ec01.jpg
http://farm6.static.flickr.com/5309/5778920840_7057a798c2.jpg

after looking through everythinghttp://www.scionlife.com/forums/showthread.php?t=128949

has the best DIY on the board. i cant touch it. cause i followed it. the one thin i can add. is when oing the end link suspenssion. use that 6mm allen wrench in side there. otherwise the whole thing just SPINNSSS

it looks nice, but where's the DIY?

which window vent visors are on your car?

im not sure. i got them off a member here ages ago. and the only thing u do need. is an impact gun of some sort with 22 and 19 mm sockets. u can tighten by hand wrench. but its stupidly hard.

and the only thing u do need. is an impact gun of some sort with 22 and 19 mm sockets and a set of spring compressors. u can tighten by hand wrench. but its stupidly hard.
There, fixed it for you FroZone. :P

I like it.

are your lips painted or PCd?

rims came like that!