Any tips on getting past the firewall guys? Me and my friends had quite a bit of trouble getting some wires connected to the ignition. We were thinking about routing the wires through the steering column but it seemed pretrty hard so we quit. But any info would be appreciated thanks.

 

wuts up bro...thats where i went tthrough its actually pretty easy thats what i ahve my gauge wires and stereo sytem wires.....just go through the black bushing then it should come right out under the steering whell obviously...

 

What did you use to push the wires through? We were thinking about an old wire close hanger but we only had plastic

 

im an electrician so i used a snake but yah a hinger will work just tapoe the ends so you dont poke anything just use anything strong but flimbsy

 

Look behind the glove box. There is a gromet you can put a hole in a run all your wires through.

 

look behind the brake pedal...theres a rubber housing....behind that rubber housing is an opening that leads traight to your engine bay....good luck

 

theres a rubber gromet behind the ecu on the passenger side, very easy to get through. this is where I ran my power wire.