I was reading through the TSB about the rattling on the glove box...but bending the striker did no help.. =(

i finally found out that when you take the glove box apart, there are a lot of wires running behind, and that was hitting the dashboard...
just put some foam around the wires...and VIOLA!!! it's gone =)
you can also put some felt tape where the wires are hitting as well...

 

good job!

only thing that annoys me that the glove box arent bolted on :? snap on sheesh!

 

yeah tell me about it...

my next project is to just rip by dash about to find out the damn rattling noise as well...
however, i think i'll just let my dealer take care of that...i don't think they followed all the TSB procedures... =(