hey gang....sorry i have been MIA for like a year (that whole work thing really bites) but i'm back...ok down to business, i am about to install a DC sports header and a Megan downpipe. is there any tips about how i should do this, they sent me some directions but im talking about the O2 sensor that i have heard needs to be replaced after ther header is installed. if i need to get one, where would i go? also is there some way to be extra gentile with it and not need to replace it? are there any specific tools besides the usual ones that i will need?

i will also be putting on my rear TRD sway bar so if anyone has done that let me know how it went and if there is anything i should know

thanks guys and girls

welcome back!

heres a well done DIY by Kaeon
http://www.scionlife.com/forums/viewtopic.php?t=56520

as far as the O2 sensor just dont drop it, you should be fine :D

TRD rear sway bar will just require you to take some time to figure how to get it off w/o removing the exhaust. It can be done just take your time.

Welcome back as well...

Please search out the O2 Antifouler setup, as you'll need to do that to avoid running a CEL. Follow the instructions and it's pretty much onbolt, rebolt.

sweet! these will help alot

i will tell you all how it goes when i am done

thanks again gang

hey if its not too lat,e do you have rims, thats alwaysa must, some shoes on the ride, big eye catcher,

not touching the outside till the engine work is done...first speed, then looks

Putting on a sway bar is not hard if you raise it enough off the ground. You will not have to remove the exhaust.

get a torque wrench...torque everything to spec!!!