|
View Full Version : Installed my Header!!!! CRAracer05 04-22-2007, 12:39 AM Well i just installed my header the other when I got off work. I have the dc sports header, and I did the antifouler mod, 200 miles later I get a CEL o2 sensor bank one is this the primary sensor or the secondary sensor or does bank one refer to both sensors? If it is the the second sensor i'm going to try to add another antifouler. :nails: Mugetsu 04-22-2007, 02:52 AM Ohh that sucks, hope its not the primary,2 foulers should of done the trick... VVV LOL didn't think to ask that! great advice! VVVV (edit) KINGxOFxSKA 04-22-2007, 04:06 AM did you install the antifoulers on the spipe or on the header itself? CRAracer05 04-22-2007, 11:35 AM S-pipe boostaddict 04-22-2007, 03:16 PM i dont get why everyone is throwing CEL with a header...is it all types of headers for a tc or just certain ones that are causing CEL's? Mid_Life_tC-risis 04-22-2007, 05:41 PM I believe bank 1 is the A/F ratio sensor on the header, bank 2 is the heated o2 sensor in the S-pipe. Check the service manual in the tech section. Mugetsu 04-22-2007, 06:30 PM i dont get why everyone is throwing CEL with a header...is it all types of headers for a tc or just certain ones that are causing CEL's? any header will throw a cel on the TC the key is getting a header that responds well to the antifouller mod... caveman 04-22-2007, 06:56 PM AW headers respond well to the antifouler, roughly 5K miles...no CEL.... boostaddict 04-22-2007, 11:23 PM ic and where do you buy the antifouler mods...im still lookin for compainies that have good prices and products Mugetsu 04-22-2007, 11:40 PM you either make it your self(costs about 5 to 10$) or you buy it on ebay for 10 to 15$ Most people make it themselves, but i know some don't have the time or tools for it. good rule is if you paid more than 15$ for it shipped...you got ripped lol Mid_Life_tC-risis 04-22-2007, 11:47 PM OK did some research when I should've been paying bills & doing stuff I NEED to do. :P "Bank" = cylinder bank. Since we don't have V6/V8 we only have Bank 1. "Sensor 1" = wideband oxygen (used as air-fuel ratio) sensor on header "Sensor 2" = heated oxygen sensor on s-pipe Check your CEL code to see which sensor has the problem. Here's a link to a thread in the FI section. Turbo folks deal with this too. http://www.scionlife.com/forums/viewtopic.php?t=118679 caveman 04-23-2007, 12:59 AM ic and where do you buy the antifouler mods...im still lookin for compainies that have good prices and products Pep Boys....lol |
|