Clutch Engagement Adjustment
#1
Clutch Engagement Adjustment
Is there anyway to adjust the engagement? I jsut installed a 6 puck Comp Clutch and it Pulls out right off the floor and doesnt disengage until I push it completly to the floor. Is there a way to adjust the pedal for a better pull that is closer to the middle of the clutch pedal travel?
#3
I'm having the same problem. Ive change the master, replaced the rubber line to a hard line, bled the ____ out of it, adjusted the pedal all the way up top, added a longer rod on the slave, I'm all out of ideas. It sucks because I can't go through the gears quickly, it grinds the gears. Please some one HELP!!!!!
#6
I'm having the same problem. Ive change the master, replaced the rubber line to a hard line, bled the ____ out of it, adjusted the pedal all the way up top, added a longer rod on the slave, I'm all out of ideas. It sucks because I can't go through the gears quickly, it grinds the gears. Please some one HELP!!!!!
You say u did adjust the pedal so there is some adjustment on the floor or did you have to modify anything?
#10
Is there anyway to adjust the engagement? I jsut installed a 6 puck Comp Clutch and it Pulls out right off the floor and doesnt disengage until I push it completly to the floor. Is there a way to adjust the pedal for a better pull that is closer to the middle of the clutch pedal travel?
#11
Did you ever actually get a real answer or solve this issue? I just picked up a 2007 Psion TC, it just had its clutch replaced with a stage to clutch. What I notice is it engages about and 2 inches from the floor. When I am completely stopped, I have to jam it all the way into the floor as hard as I can just a shifted into first gear without it grinding. And even then sometimes are here are some grinding. It seems like it’s not fully engaging but I’m not having any sleeping when I’m driving. Any help would be greatly appreciated
Unlike older clutch systems that use a cable to adjust the clutch, ours uses a hydraulic system integrated with the brake reservoir. So, for higher stage clutches, the higher clamping force of the pressure plates causes the low disengagement and re-engagement of the clutch as more pressure is now required to compress the pressure plate fingers completely down. Sometimes this can be too much pressure for the hydraulic system, and it results in the low disengagement and re-engagement of the clutch, as I said before.
The clutch disengagement/engagement height could possibly get better once the clutch is broken in, assuming your clutch is not broken in yet. I would have someone press the clutch while you watch the slave rod move (look for weird/bad movement) or record it with a device if you can't get someone to press the clutch. You could also inspect the slave cylinder as well as the brake reservoir.
Thread
Thread Starter
Forum
Replies
Last Post
WRX1316_TcVicent
Scion tC 1G Drivetrain & Power
5
07-22-2021 06:06 PM
Subaru86
Scion FR-S Suspension & Handling
0
07-31-2015 04:33 AM
05, 2002, adjust, adjusting, adjustment, clutch, engagement, lancer, low, mitsubishi, problems, scion, tc, xa, xb