This isn't necessarily the best way to do it but it's not wrong by any means. If you want to be able to turn it on whenever you want, even if the car isn't running, the right way would be to go to the battery for power but then you have to run a wire through the firewall and that's a pain in the ___. The other options you have if you want to be able to turn them on when the car isn't running, is you can go to the ignition harness below the driver side dash and you'll find 12 volt constant in a big bundle of wires but you have to cut all the tape off the harness. Easiest way to get constant power for an accessory is from behind the radio. The info for the wiring of the radio is super easily available on the internet. Once you find your 12v+ and ground wire just strip the wire, poke it with a pick, stick the wire through, wrap the wire around the one your tapping in to, and tape it up, then add a zip tie to secure the wire to the one your tapping into (you can solder if you would like). And and run your wires. You'll need to add a switch in series on the 12v to the badge so it's not on all the time. And that's it easy least man...Good Luck!

____