Dome Light Housing Removal
#1
Hello Everyone,
I tried changing out my dome lights today, some how popped both bulbs up and now i can't reach either one of them. so I am without light now lol.
How do i retrieve those bulbs?
Hello All,
I need to remove the housing for my dome lights. Would someone be able to tell me how do so? I was able to wiggle my way through with a flathead, but I don't want to break anything.
If someone could please walk me through it, I would GREATLY appreciate it.
Thanks!
I tried changing out my dome lights today, some how popped both bulbs up and now i can't reach either one of them. so I am without light now lol.
How do i retrieve those bulbs?
Hello All,
I need to remove the housing for my dome lights. Would someone be able to tell me how do so? I was able to wiggle my way through with a flathead, but I don't want to break anything.
If someone could please walk me through it, I would GREATLY appreciate it.
Thanks!
Last edited by MR_LUV; 02-26-2017 at 01:11 AM.
#2
Hello Everyone,
I tried changing out my dome lights today, some how popped both bulbs up and now i can't reach either one of them. so I am without light now lol.
How do i retrieve those bulbs?
Hello All,
I need to remove the housing for my dome lights. Would someone be able to tell me how do so? I was able to wiggle my way through with a flathead, but I don't want to break anything.
If someone could please walk me through it, I would GREATLY appreciate it.
Thanks!
I tried changing out my dome lights today, some how popped both bulbs up and now i can't reach either one of them. so I am without light now lol.
How do i retrieve those bulbs?
Hello All,
I need to remove the housing for my dome lights. Would someone be able to tell me how do so? I was able to wiggle my way through with a flathead, but I don't want to break anything.
If someone could please walk me through it, I would GREATLY appreciate it.
Thanks!
#3
How did you guys even manage to do that lol?
You can pull the entire overhead assembly straight down. It's just held on with 4 red push-clips. After removal, the bulb bases just twist into place.
Shown here in page 3 (homelink mirror install instructions) - http://toyotaparts.sparkstoyota.com/...2090tCinst.pdf
You can pull the entire overhead assembly straight down. It's just held on with 4 red push-clips. After removal, the bulb bases just twist into place.
Shown here in page 3 (homelink mirror install instructions) - http://toyotaparts.sparkstoyota.com/...2090tCinst.pdf
#4
How did you guys even manage to do that lol?
You can pull the entire overhead assembly straight down. It's just held on with 4 red push-clips. After removal, the bulb bases just twist into place.
Shown here in page 3 (homelink mirror install instructions) - http://toyotaparts.sparkstoyota.com/...2090tCinst.pdf
You can pull the entire overhead assembly straight down. It's just held on with 4 red push-clips. After removal, the bulb bases just twist into place.
Shown here in page 3 (homelink mirror install instructions) - http://toyotaparts.sparkstoyota.com/...2090tCinst.pdf
Last edited by zhawn; 12-03-2021 at 10:03 PM.
Thread
Thread Starter
Forum
Replies
Last Post
nae02etc
Scion xA/xB 1st-Gen ICE & Interior
2
08-02-2004 06:11 AM