OEM Style Fog Lights
#1
OEM Style Fog Lights
Hey guys im a newbie to these forums, and slightly a newbie to the tc!
I bought a 2011 tc a couple of weeks ago and I am slowly building it. I just got a set of fog lights for it and Im a bit stuck on installing them. I haven't found a sticky or any threads of "how to"
So, is there any that I am missing? or any help I could get? (TRD sparks pdf is a bit confusing to me)
I bought a 2011 tc a couple of weeks ago and I am slowly building it. I just got a set of fog lights for it and Im a bit stuck on installing them. I haven't found a sticky or any threads of "how to"
So, is there any that I am missing? or any help I could get? (TRD sparks pdf is a bit confusing to me)
#2
Where did you got stuck? Instruction is pretty much straightforward.
Hey guys im a newbie to these forums, and slightly a newbie to the tc!
I bought a 2011 tc a couple of weeks ago and I am slowly building it. I just got a set of fog lights for it and Im a bit stuck on installing them. I haven't found a sticky or any threads of "how to"
So, is there any that I am missing? or any help I could get? (TRD sparks pdf is a bit confusing to me)
I bought a 2011 tc a couple of weeks ago and I am slowly building it. I just got a set of fog lights for it and Im a bit stuck on installing them. I haven't found a sticky or any threads of "how to"
So, is there any that I am missing? or any help I could get? (TRD sparks pdf is a bit confusing to me)
#4
First of all don't cut or drill anything. All you need is a Phillips screwdriver
A ratchet with a 10mm socket
Now, you can lift up the car a bit to make this easier because you will struggle a lot. On the bottom of each corner of the bumper there is a small bracket that opens and has 2 10mm screws, remove them and then stick your hand through there and push out the stock vents.
the fog lights slide in and are held by 1 screw. your bumper already has the existing screw hole for the fog lights to sit in place.
A ratchet with a 10mm socket
Now, you can lift up the car a bit to make this easier because you will struggle a lot. On the bottom of each corner of the bumper there is a small bracket that opens and has 2 10mm screws, remove them and then stick your hand through there and push out the stock vents.
the fog lights slide in and are held by 1 screw. your bumper already has the existing screw hole for the fog lights to sit in place.
Thread
Thread Starter
Forum
Replies
Last Post
SkillFreeJake
Scion tC 2G Aero & Exterior
17
07-27-2015 12:34 AM
carid
Exclusive Sponsored Sales
0
01-08-2015 11:33 AM
TheTripleC
PPC: Vehicles
1
01-04-2015 06:46 PM
umnitza
Exclusive Sponsored Sales
3
12-01-2014 06:26 PM