xB brake light - how to change the bulb?
#1
xB brake light - how to change the bulb?
I'm asking because I don't know if I need to remove the tail light in order to change the brake light bulb (7443). mine went out and i dont have access to a socket wrench in case i need to take the light/housing off.
so - do i need to remove the tail light housing itself to change the brake light bulb?
i appreciate your replies! thank you guys in advance,
- sh00k
so - do i need to remove the tail light housing itself to change the brake light bulb?
i appreciate your replies! thank you guys in advance,
- sh00k
#2
You don't have to... access back there sucks though. You have to take the access panel off in the hatch. The upper bulb is the brake light, the bulb twists out with a 1/4 turn. Pop the old one out and the new one in. That's pretty much it. Again, it helps to have small hands. And don't drop the bulb, it'll fall into the fenderwell, and it's a pita to get it back out.
Hope I've scared you enough.
Hope I've scared you enough.
#3
hahaha - thanks for the tip, dude. it's ridiculous enough to post a q about how to change the light bulb... lol - but the only tools i have are a screw driver and a socket set with like 10 sockets - that's about it. lol... so i was wondering if i just needed to buy any tools to do this...
i appreciate it, burst,
- sh00k
i appreciate it, burst,
- sh00k
Thread
Thread Starter
Forum
Replies
Last Post
xBSciontist
Scion xB 1st-Gen Aero & Exterior
6
06-18-2019 03:06 PM
VCUBoy714
Scion tC 1G ICE & Interior
2
01-05-2015 08:46 PM