WendysOrBust

I'm just a little confused here and I just need some quick help before I go and start cutting up wires on the harness. Can anybody point me to the right ECU pinout for the camcom unit? It says that the Tc's ecu uses the wiring "T0-102" but I can't find that diagram in this list.



Also I have a 07 Tc, and I know the 05-06 ecu is a bit different than the 07-08 ecu so would this be the same?

Thanks in advance, guys. Once I figure out which one it is it should only take me a few mintues to do.

WendysOrBust

Anyhelp would be appriciated, I just want to install it and get it out of the way tonight since I have a bit of free time and have had it sitting in my back seat for about a month now.

WendysOrBust

anyone plz?

WendysOrBust

bumb I still need to install this!

HighMPGTesting

Don't feel bad. I put in for help with the ignition coil wiring, and no one responded with an answer. I have an electical manual for an '08 tC on order for my car from the dealer. Once I get it, I'll post.

WendysOrBust

I FIGURED IT OUT!!!! I had to email Hideo from powerenterprise and he was quick to respond to me. He or they even updated the site with VERY useful information.

Camcom Page
Pdf file with all of the 07-08 Scion Tc Ecu Pinouts from P.E.

After comparing wiring diagrams with the ecu pinouts I figured out that to wire the Camcom into an 07-08 Tc you need to follow the T0-13 Ecu diagram (refer to picture in original post)

Excellent, I'll have this thing on tomorrow.

kalvinz61

Glad to hear you got it on lol whats it for anyway?

WendysOrBust

Its a very basic device used to tune your cam angles and your afr's. People with full bolt ons and a dyno tune have gotten very good results, and its also a cheap and alternative to going with a greddy ultimate or aem fi/c, which require you to really know how to work the software.