Where to run power wire through?
#2
There is a rubber groundnut just below where the gas pedal is connected. There is actually a hole in it already from the inside, u just have to cut the other end (engine side) to open it up.
Go look at the install manual for the OEM Audio + system. That's how that system is installed
Go look at the install manual for the OEM Audio + system. That's how that system is installed
#5
I know this is an old thread... but maybe other people may search it in the future....
I ran my power wire on the driver's side hugging the top of the piece of styrofoam just below the front pillar. Once the power wire is past the styrofoam, I dropped it down between the door hinges where the rest of the wiring for the locks, etc. enters the cab. No drilling holes.
I ran my power wire on the driver's side hugging the top of the piece of styrofoam just below the front pillar. Once the power wire is past the styrofoam, I dropped it down between the door hinges where the rest of the wiring for the locks, etc. enters the cab. No drilling holes.
Thread
Thread Starter
Forum
Replies
Last Post
SkillFreeJake
Scion tC 2G Aero & Exterior
17
07-27-2015 12:34 AM
Green_rino
Scion FR-S ICE & Interior
1
01-20-2015 01:41 AM
randode
Scion xA/xB 1st-Gen ICE & Interior
44
06-29-2004 04:19 PM