and my old wheels, my daily drive height.

dumped on Ksport coils

car was so high with the tc wheels i hated it.

 

i agree i kinda dont like it cause i can actually go over a speed bumper with a little of scrap, but before i couldnt even go over one...these wheels have to go..lol but until i get a new set..

 

LOVE THIS, LOOKS SO RIGHT!

 

I have the same set up just super white

 

thanks

 

Love the look!

 

I have a 2011 xb and i just purchased 4 2012 tc rims, will i need to swap out all my wheel studs with that of the 2012 tc?

Sent from my Transformer TF101 using Tapatalk 2

 

No you just need the lug nuts for the TC wheels.

 

Thanks King, much appreciated.

Sent from my Transformer TF101 using Tapatalk 2

 

Can someone provide a link to the exact lug nuts needed to run the stock tc rims? I'm using the stock steely ones because the guy i bought the car from already had them on. Also if there is another alternative to the stock lug nuts please let me know which exact one.

Thanks

 

Any spline drive acorn nuts should work with the correct thread pitch.

To figure out the thread pitch, you'll have to Google it. Pretty easy.



Oooooor... you could run down to your local wheel and tire shop and buy some there.

 

Seems i need the flat washer type and only toyota sells that kind. I will just buy some on eBay because they are 7 bucks a piece at the dealership

 

Oh got you! I didn't realize that! Good to know!
And $7 apiece from the dealer!? Pssssh. Cop off of eBay, for sure. You can probably even find some with the spline drive.

 

http://www.sfxperformance.com/parts/GOR73137TXLB-20.htm

 

I ordered from eBay, 26 bucks shipped. Thanks for the suggestion though!

 

 

@neresh Looking clean!!!

 

Thanks drew. I like the tc rims. Not too flashy. I'll get some spacers for the rear wheels sometime.

 

Tc wheels should have came on the XB from factory. They look too perfect on there.