Perrin Pulley Installation Guide
#101
Just installed an Agency pulley on my xB using these directions. This was a good guide, but i had to loosen the bolts to the power steering in order to get the new crank pulley to line up properly.
#102
For reference to anyone coming back here, the torque specs for the crank pulley is 95ftlb.
I tried getting my Agency Power pulley on, but couldn't do it. Got the belts off, but as some of the advice on here says, having the belts on for cracking the bolt (and having it in fifth gear was advice I have from a friend off the forums) would make that easier. The hardest thing once you find the power-steering bolt is getting it loose enough. At least in my Echo, it's very close quarters, so you barely turn it before you have to take the wrench off again. I couldn't get a ratchet or ratchet-wrench in there-- had to use a box-end. With the new info, I'll try it again.
I tried getting my Agency Power pulley on, but couldn't do it. Got the belts off, but as some of the advice on here says, having the belts on for cracking the bolt (and having it in fifth gear was advice I have from a friend off the forums) would make that easier. The hardest thing once you find the power-steering bolt is getting it loose enough. At least in my Echo, it's very close quarters, so you barely turn it before you have to take the wrench off again. I couldn't get a ratchet or ratchet-wrench in there-- had to use a box-end. With the new info, I'll try it again.
Thread
Thread Starter
Forum
Replies
Last Post
NonStopTuning
Exclusive Sponsored Sales
4
01-20-2015 05:20 AM
TheRedBox
Scion xA/xB 1st-Gen Drivetrain & Power
31
12-02-2003 04:53 PM
Besk_one
Scion xA/xB 1st-Gen Drivetrain & Power
0
11-18-2003 05:41 AM