You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
I installed the Oznium lighted switch for my fogs tonight on my 2006.5 TCM xB. Whe I did the install I followed the instructions on Club xB to run them independantly... ( Found Here, http://www.clubxb.com/forums/showthread.php?t=12605) When I installed the switch if there is a wire connected to the #3 terminal it either stays light all the time, even when the car is off, or it never lights up. However, when I leave the #3 terminal unhooked and just hook the green wire into the switch and ground it to the car it works justs fine, as in it lights up only when the fogs are on. My question is this, should I be worried about that disconnected terminal?
04-05-2012, 05:05 AM
Fog Light Switch Question.
