weekend bump.

 

I have 5 sets left from my last run, 50.00 shipped now till Friday!!!! Can't get them cheaper anywhere else!

 

Hey bbszero,

I would like to purchase a set. Can I have paypal info?

Also I will need to replace my stock wheel studs with extended ones for front and rear. I have a set of Volk wheels and because how they mount and offset, the lug nuts only turn 5 rotations before they are tight on the wheel/threads of the stud. Not enough to be safe I imagine. So would you know what brand, specs, etc of extended wheel studs I would need for both the front and rear of my 05 XB?

Thanks,
Will

 

These are just for the rear. They bolt on behind the hubs, no need to mess with your studs.

 

Yes I understand they are for the rear. I was just asking if you may know where to purchase extended studs because of wheel offset/wheel hub issue.
But anyways, I would like to purchase a 10mm spacer kit. What is your paypal info?

Thanks

 

i'd think any wheel shop could get the right ones for you, and put them in. Discount tire or similar. my paypal is cadams@jdott.com, i'll get them out tomorrow morning if you pay tonight. Thanks

 

Hey,

Sending paypal payment tonight. Thanks.

I'm actually going to order the extended studs from fastscion.com as they sell the Itchiba extended studs or extended studs made by H&R. Now its a matter of ordering the correct length.

Will

 

any camber shims??

 

Not making any right now.

 

Payment received, they are going out USPS Priority mail this morning.

Thanks again.

 

I have 5 sets of 15mm's. they are 55.00 shipped! These go fast!!!!!

 

bump for a good guy
got some of these about a week ago
now to get them on th B

 

Thanks for the bump liljoe!



********I am making a run of 20MM hub spacers, only 5 sets to start. They are going to be 65.00 a pair, shipped. Grade 10.9 hardware included. Reserve a pair now*******

 

What are you making these out of?

 

6061-T6 aluminum.

 

Revised original post, making some 20mm spacers now.

 

how easy are these to install?? i wanted 20mm for the rear, i have the 19" trd wheels on with the TRD lowering spings not so sure of how much room i have just want to get rid of the "indent" these wheels have. maybe get them flush to the body

PM me

 

PM sent

 

20mm are done and ready to ship. I'm running 20mm with stock steelies, here's a pic.

IMG_0918.jpg

 

http://www.rotawheels.com/wheels.asp?wheelid=27

I'm running these... I'm not sure of the offset.. but it is 15 x 6.5

I know they had to put some lame ones up front cause it hit the caliper...

i probably need front and back...