tC: weezy part out
first is my turbo kit
titanium manifold equal length top mount
percision 6262 turbo with .63 hotside v band( turbo has 2k miles is ported with billet wheel)
tial bov
tial wg
world racing intake mani (i/c pipe's made for the mani)
full 3 inch stainless steel exhaust goes all the way untill the axle back
big front mount intercooler
turbo toyota's vaccum block
turbo smart boost controller
pro sport boost/ oil gauge
aem uego
tri pod a pillar
tapped oil pan
dw 700cc pnp injectors
3500 shipped might consider going a little cheaper if someone is serious
aem ems works perfect 1,050 shipped
comes with everything map sensor iac etc..
exedy twin disk (awsome clutch) 700 shipped
my built motor looks like 1 of the valves are bent will inspect once i get the motor out but motor still starts up and runs but won't stay running has 2500 miles on it
if someone is interested in the head as is it has a sick nasty port n polish job with 3 angle valve job bc stage 2 cams 750 shipped the motor was very quiet even being fully built
short block has
89mm je pistons
acl race bearings
pauter rods
GE sleeves
arp main studs
arp head studs
1500 picked up 1600 shipped everything is like new still
ill post up pictures later
titanium manifold equal length top mount
percision 6262 turbo with .63 hotside v band( turbo has 2k miles is ported with billet wheel)
tial bov
tial wg
world racing intake mani (i/c pipe's made for the mani)
full 3 inch stainless steel exhaust goes all the way untill the axle back
big front mount intercooler
turbo toyota's vaccum block
turbo smart boost controller
pro sport boost/ oil gauge
aem uego
tri pod a pillar
tapped oil pan
dw 700cc pnp injectors
3500 shipped might consider going a little cheaper if someone is serious
aem ems works perfect 1,050 shipped
comes with everything map sensor iac etc..
exedy twin disk (awsome clutch) 700 shipped
my built motor looks like 1 of the valves are bent will inspect once i get the motor out but motor still starts up and runs but won't stay running has 2500 miles on it
if someone is interested in the head as is it has a sick nasty port n polish job with 3 angle valve job bc stage 2 cams 750 shipped the motor was very quiet even being fully built
short block has
89mm je pistons
acl race bearings
pauter rods
GE sleeves
arp main studs
arp head studs
1500 picked up 1600 shipped everything is like new still
ill post up pictures later
Last edited by weezyfbayba; Apr 27, 2011 at 11:23 PM.









