Fender Rolling in Socal?
 

Anyone have a fender roller for rent or know where I can get my fender rolled professionally in LA/OC? None of that baseball bat stuff (i've done it before).

I contacted CEC and Wheel Warehouse who said they only fender roll at the time you buy a set of wheels from them. EF1 Motorsport in Long Beach quoted me $50 per corner. I remember The Wheel Supply in Walnut quoted me like $30 per corner (I lost their contact info).

Any help is appreciated. Thanks.

I cant put these on until I roll the rear quarter panels.
http://users.adelphia.net/~hkspeed/SSR2.jpg
http://users.adelphia.net/~hkspeed/SSR1.jpg
http://users.adelphia.net/~hkspeed/SSR3.jpg

those are some beautiful wheels....
your tc is going to look sweet!

and i too would like to know this info aswell!!

nice......

how do you get your finder wells rolled wont it mess up your paint

heat gun is the answer....

somehow try to get a hold of oliver.. i think he works at scion of glendora?? but if you do.. he got his fenders cut and then repainted.. hes running a pretty low offset on his car the last time i remember.. but i saw his car over a year ago..

CUT?
no cutting please... just a lil massaging!!

u can roll the fender and not have the paint crack...its all in the technique and experience of the person doing it.

I went to Superautobacs to have my fenders rolled. It cost me $100 for both rears to be rolled. I rolled them myslef but it wasnt good enough and I was rubbing like crazy. I say pay the 100 bucks and ahve it done right and save your tires all at the same time.

hey Mike ...
does M2Motoring roll fenders???

what's the offset on the SSRs?

Damn, MattyRattyPoo's on it. Yup, Superautobacs has the correct tool
and they're located in Stanton (Orange County). They did mine in about
an hour.

Thanks for the replies. So here are my choices so far.

Super Autobacs will roll my fenders for $50 each. No guarantee against paint chipping.

The Wheel Supply (in Walnut) recommends cutting/grinding down the fender lip because they feel most Japanese cars use thinner sheet metal that can buckle from the pressure of a fender roller. On European cars, they recommend rolling instead of cutting. I've seen 240SX's where the rear quarter panel buckled from rolling. They use silicon sealant to prevent rust. $50 per wheel.

EF1 Motorsports in Long Beach. Fender rolling. $50 each wheel. No guarantee against chipping.
http://www.ef1motorsports.com/index....037&pageid=101

what do you guys think?

id do the fender cutting because that metal is gonna stretch and the paint is on there.. so that stretches too.. it might crack..

I had minimal paint chipping (on an xB) when superautobacs rolled mine. The chipping was all on the inside of the fender that's tucked under the car so a little touch up paint did the trick. The tool did a great job of rolling it nice and flat.

Vision Autosport in Hacienda Heights can do it also.

http://store.visionautosport.com/index.html

thanks. they quoted me $35 per corner and theyre open Saturdays.
:)

i got my fenders rolled at Super Autobacs today. $50 per corner. They did an excellent job.

Where's the professors or are u waiting til Wednesday to break them out.

he has pics in this thread....

https://www.scionlife.com/forums/viewtopic.php?t=101693