uhsentc

images not working?

domincnTC

iTrader: (2)

hopefully it will be, it has been a long wait for these!!!


they will be installed on friday then you can exactly what they will look like.
but wont be completely maxed out just yet.
getting the fenders rolled sunday to complete the process with the 10 mm spacers for the rear.

domincnTC

iTrader: (2)

here is an update, still havent got it to the height and giving time to settle.
with school dont have all the time to play around with the em
fronts will be lower this weekend, rear has about a thread left
but very pleased with the stance gr+, if you dont have them invest in them!!!!






will do a better shoot this weekend.

Skeeeett

iTrader: (5)

nicee def looks good..thosse coils are sexii

and is that 1 thread left with all the perches in still? bc i know people remove the 2 lower perches

kevin091988

damn thats as low as the rears go? I know they arent settled, but thats still a lot of tire showing on 18s! Car looks sexy though

kevin091988

oh and since no one else commented on it, did you paint the trim around your door windows?

domincnTC

iTrader: (2)

it is just one thread left with what the spring preload was set to.

they can go lower but i only lowered it to where the preload was set to.
but thank you :D, im planning on lowering it more this weekend when i get the time


no i didnt paint it there is like black electrical tape you can peel off from the inner door, pretty simple but kinda thinking i like the all black look instead.

jeremydoc

iTrader: (11)

hey man. do u think u could do me a favor. could u take a pic of the exhaust where the second hook connects to the car. i have an hks also, but it didnt come with the hook to connect to my car since i bought it used. so, its only holding onto the bolts to the midpipe and then the rubber grommets of the first and third on the actual exhaust itself. i had to use a chain to tied it down or else it sits too close to my bumper. its already started to melt off a piece of my bumper.

this is the part of the exhaust i wanna see and how its connected to the car.


thanks in advanced

domincnTC

iTrader: (2)

just curious to know what happened to the hook cause it is welded on there?
yea i will grab a picture in the afternoon and send it to you asap!!

Tom11x

iTrader: (1)

hows the ride with the coils

domincnTC

iTrader: (2)

quite smooooth i would have to say, very comfortable.

dropzone

What damper settings are they at? Did you get the standard GR+ or Meng exclusive with higher spring rate?

domincnTC

iTrader: (2)

im not sure what the damper setting are, its what they were when i got them in the mail. and yes they are the Meng exclusive.

domincnTC

iTrader: (2)

lowered the front 1/2 an inch more, now just need to get the alignment done.

kevin091988

you should check the damper settings on them as they might be stiffer on one side than the other etc. Car looks hella good dude

TeeCizzle

Put the Blk Vinyl back on ur Door Frame!....

Other than that looks cool!

domincnTC

iTrader: (2)

thankss :D.
i will check it out tomorrow and let you know.

domincnTC

iTrader: (2)

thank you.
and no worries im going to be putting it back on.

TotalChaos

hella clean car bud! Looks real nice! Did you get the coilovers from PTuning?

domincnTC

iTrader: (2)

thanks :D
i got some more pics from a meet last night, il post them up this weekend.

i got the coilovers from Meng Motorsports.