Alright It's 2am in NH and I'm bored. So I took off the front emblem to make measurements and see what it looks like.







Measurements:
Width = 4 7/8(12.4cm)
Height = 3 5/16(8.4cm)


Luckily, my mother drives a Toyota Rav4 2005 so I debaged it




It did not have the black backing and did not really fit. It popped out a second after I took the pic



Conclusion:
2005 Rav4 doesnt work (Unless brute force is used of course)

....Keep looking

 

Cannot just apply double-sided tape or something of the same worth to a toyota emblem and stick her on the black backing?
They look to be close to the same size?

 

most likely will work but id have to break of the clips from the toyota emblem.
so kinda hard to tell since i dont want to break my mother's emblem.

 

If you're going to swap emblems, you should really go Lexus!

 

IDK....the car just doesn't look like Lexus at all, where as Toyota badge is cool and humble IMO.

 

Take your measurement to the dealership and compare them to the Toyotas on the lot... maybe the Yaris or Corolla would be close.

 

there was a coupe yaris in the parking lot and the badge was HUGE!

 

^ Maybe it just looked huge because it's such a small car!?

j/k... I never paid much attention to the Yaris, just throwing out ideas.

 

haha i had the scion badge in hand, the yaris one was half an inch bigger in each direction

 

Why not get the Rav-4 badge, brake the clips and stick it onto the black backing. then install the emblem back on?

 

as i mentioned, it could work with brute force. i'll take a look at it again today while the sun is up however the rav4 badge seemed a little too big so it may not fully fit in the cut out even after its glued to the black backing.....may have to file the edges

 

How bout just rockin the scion emblem. One in the same anyways... Not like your gonna get mad recognition for it being a Toyota cause technically it already is a toyo...

 

it's not about recognition here, just ideas out loud and more ways to make the car your own. I'd rather have no badges at all but the front leaves no choice. I'm completely removing the rear one and filling in the holes and the indent

 

is it possible to take the emblem apart and put it back without the black backing? would the clips still matchup?

 

could ask the german toyota guy if hes able to order those parts and i could send them over to you... if you are any interested, throw me a msg

 

in the pic with toyota badge(last one) there is no black backing so it looks like ____ and no the clips dont line up at all

 

looks like no toyota or lexus badge are the same size

Brute force will be required

 

Any Lexus badge close enough?

 

the closest ones are 3mm too big on each side

https://www.scionlife.com/forums/sho...4&postcount=84

 

what if you just cut off the clips on the toyota and glued it to the scion plastic piece and put it in? or is the toyota emblem too big to where you cant stand it?