JL Audio 500/1 amp settings
#1
Senior Member
Scikotics
SL Member
Thread Starter
Join Date: Dec 2006
Location: Patuxent River, MD
Posts: 2,476
JL Audio 500/1 amp settings
I just recently upgraded my system from a single JL 8w7 in a sealed box to two 8w7's in ported boxes. I also upgraded from the 250/1 to a 500/1, and holy crap is there a lot of settings on the 500/1. I'm still finishing the boxes so for now the subs are mounted in unfinished MDF boxes. I hadn't planned on properly tuning the amp until the boxes are painted but was hoping some had taken the time already and use theirs as pre-sets.
Specific setting I'm looking for are:
- Infrasonic filter frequency
- Parametric EQ "Q"
- Parametric EQ center control frequency
- Parametric EQ Boost
- Low-Pass slope 12 or 24 dB
- Low-pass frequency
- Input sensitivity
Hopefully someone here on SL has my setup and took the time to tune it per the manual. When I get around to it, I'll post my settings after tune.
Specific setting I'm looking for are:
- Infrasonic filter frequency
- Parametric EQ "Q"
- Parametric EQ center control frequency
- Parametric EQ Boost
- Low-Pass slope 12 or 24 dB
- Low-pass frequency
- Input sensitivity
Hopefully someone here on SL has my setup and took the time to tune it per the manual. When I get around to it, I'll post my settings after tune.
Thread
Thread Starter
Forum
Replies
Last Post
Beesh
Scion xA/xB 1st-Gen ICE & Interior
3
01-09-2015 06:30 PM
carid
General Tech and DIY
0
12-04-2014 09:35 AM