Removing Rear Seat Bottom
Anyone know how to remove the rear seat bottom. I need to install rear Wet Okole seat covers and it requires removing the seat. I can't seem to find any old threads that show how to do it.
Last edited by MR_LUV; Oct 21, 2017 at 10:01 PM.
If this is an xA grasp the seat right in the middle of where a person on the left would sit and pull up hard, it should unclip, do the same for the right.
Now lift the seat up until it is about at a 45 degree angle, and then push the cushion towards the back.
There is a loop of heavy gauge wire in the seat cushion, and a hook on the back of the seat back that you need to disengage.
You can see these if you pull everything out of the "trunk" and look in the middle of the seat from the trunk space.
Installation is just the reverse
Now lift the seat up until it is about at a 45 degree angle, and then push the cushion towards the back.
There is a loop of heavy gauge wire in the seat cushion, and a hook on the back of the seat back that you need to disengage.
You can see these if you pull everything out of the "trunk" and look in the middle of the seat from the trunk space.
Installation is just the reverse
Last edited by MR_LUV; Oct 21, 2017 at 10:03 PM.
Thread
Thread Starter
Forum
Replies
Last Post
kdepew
Scion xA Owners Lounge
4
Oct 16, 2018 12:35 PM







