I KNEW IT!!!! copy cat.. :P :rofl:

Looks slick Jason!! I like it!!

thanks! I really like the new look.

That looks really sweet and for $70 color matched I think its a pretty fair price.

Thanks!! the color match is flawless!!

I agree, for the price its a steal, and the color match is very good as meatcutter says.

x2 good price

Great! Now I'm convinced. I'm very skeptical about paying $70 for such a small attachment for my car. But after the frequent back-to-back talk about paint, I'm convinced it's a fair deal.

Now it's time to convince the girl that a shark fin antenna is next on my list.

Mine has been on a couple of weeks now, and gone thru an auto wash twice, still looking good. Honestly, at $70, if the thing broke every 2 years I would not care.

that's good to hear. I've been a little worried about the car wash..

Nah. Man, I just put a spoiler on my wifes car with the 3m tape, that stuff aint going anywhere.

https://i261.photobucket.com/albums/...d/IMG_1881.jpg

That is just too clean, I must have!

I love mine.

i'm pretty much convinced to get one now too. thanks for the installation pics, definiely made it seem super easy to do.

thanks. but it's not hard to make it look easy when it is easy. the hardest part was the reach.. I used a step stool to get a better handle on the install, that and MAKE SURE THE FIN IS STRAIGHT!!!!! other than that? it was a breeze. if you get it from www.sharkfinantenna.com let Arthur know that I sent you. :)

yeah that whole make it straight thing seems like a pita to do. it should come with a paper or cardboard cutout template that hooks onto the back door so you can just place the template, place the sharkfin and bam you're done. any tips or tricks you discovered when you did yours to make it straight?

I placed the Shark Fin over the stock antenna base approximately where it would be stuck on. While it was sitting there, I put one strip of blue painters tape just in front of the shark fin, and one strip of blue painters tape behind the shark fin (each about 6" long). I then used a tape measure to mark the center line of the roof on each piece of tape.
I measured the width of the back of the fin and marked it on the rear piece of tape so that it was centered on the center line I already marked. Now just peel the paper off the 3M adhesive tape on the fin, line up the front & rear with the marks on the tape, and push down for a minute. Peel the blue tape off the roof, and you're done.

Hope that helps, I've done it that way 3 times, and every time it looked great.

__________________

Looks good, too bad they don't have the Shark Fin in RS6.0 color

__________________

Sure they do, it's listed on their website as being available for our Absolute Red!

Sure they do. I installed one on my RS6 a couple weeks ago. Looks great with the rear spoiler. Gives the back roof section a much sleeker look.

PDX_xB