Does anyone know if the ecu wiring for the 2nd gen xb is the same for the tc? if so.. isn't it possible to use the greddy e-manage from the Greddy tc turbo kit?

 

No, the wiring is not the same. The harness is different. We installed an emanage in the turbo 08 xB that we did here. All by hand.. Cutting and soldering...

 

did you happen to have a diagram for the ecu?

 

I have all the pinouts and locations written somewhere. I know I sent them to someone on the board here, maybe they will see this post and help you out. I will try to find the paperwork.

 

If someone could send them to me as well thatd be great!

 

I found these in one of my previous posts. Im not sure where we put the paperwork in the shop with the full breakdown, but this should be most of what you need...

ecu power lead - Black wire terminal A28
RPM Signal - White terminal B122
Throttle Signal - Light Green terminal B115
2 ECU Grounds - White/Black stripe terminals B44 & B46
Airflow input - Violet terminal B118

Terminal A is the smaller connector and Terminal B is the larger connector
Terminals are numbered left to right, top to bottom as if you were holding the connector and looking at the end that plugs into the ECU