Need QUICK help - door panel removal question
#1
Need QUICK help - door panel removal question
How do you get the cables off of the inside of the door panel? I don't see a screw or anything.
I have the panel removed from the door with the exception of the two cables that are connected to the interior door handle.
I have searched, but can't find anything and the gen 1 is connected differently.
Any help would be greatly appreciated.
Thanks.
I have the panel removed from the door with the exception of the two cables that are connected to the interior door handle.
I have searched, but can't find anything and the gen 1 is connected differently.
Any help would be greatly appreciated.
Thanks.
#4
There aren't any screws, but there are about 8-10 "clips" that pop out...a trim tool is highly useful for this process.
The door handle does pop out too...there is a hole that it sets in...I pulled the tabs apart and the door handle falls out...snap it back in when reassembling.
The door handle does pop out too...there is a hole that it sets in...I pulled the tabs apart and the door handle falls out...snap it back in when reassembling.
Thread
Thread Starter
Forum
Replies
Last Post
McG_XB
Maintenance & Car Care
22
02-10-2004 09:53 AM
shaefner
Scion xA/xB 1st-Gen ICE & Interior
3
10-08-2003 02:48 PM