Finally Corvette Sawblades on!
#1
Finally Corvette Sawblades on!
I'm going to share info that Was very scarce when I was trying to find concrete info to adapting Corvette Sawblades to a 2nd Gen Scion xB. This is what I did. Got the 90 -96 Sawblades Fronts are 8.5 wide with 225/45/17 and Rears are 9.5 wide with 255/40/17.
You need Spacers/Adapters that are go from 5x114.3 to 5x120.7. Adapters are 1" thick. Make sure you put plenty of Red Loc-Tite on the Adapters nuts. (Just to be on the safe side) with this combo of tires you will have "no rubbing at all" My xB has lowering springs too.
Hope this info makes it a piece of cake to the next person doing this mod!
Cheers, Robert
You need Spacers/Adapters that are go from 5x114.3 to 5x120.7. Adapters are 1" thick. Make sure you put plenty of Red Loc-Tite on the Adapters nuts. (Just to be on the safe side) with this combo of tires you will have "no rubbing at all" My xB has lowering springs too.
Hope this info makes it a piece of cake to the next person doing this mod!
Cheers, Robert
Last edited by MR_LUV; 09-11-2018 at 01:46 PM.
#3
Update
Robert,
Are you still running this set up and if so or not how did you enjoy the ride? I'm picking up my saw blades tomorrow and excited to get them polished and get them on. Anything you would change tire size,.spacer? Thanks
Mike, OH
Are you still running this set up and if so or not how did you enjoy the ride? I'm picking up my saw blades tomorrow and excited to get them polished and get them on. Anything you would change tire size,.spacer? Thanks
Mike, OH
Thread
Thread Starter
Forum
Replies
Last Post
saveacivic
Scion xA/xB 1st-Gen Wheel & Tire
1
01-30-2006 07:39 AM