get down.
Thread Starter
Senior Member




SL Member
Scion Evolution
Joined: Jun 2004
Posts: 2,726
From: Over there
ok over the past few weeks I have been working on my suspension on DOA, front and rear. Sat I re worked my rear brackets and got some more drop on them as well.
The tires are sitting on the fender wells, so until I can strip out the back of the car and tub them this is how it is going to sit. Withe the 16s on the front frame braces drag the ground so it is as low as it is going to go for now as well, until I can notch the frame.
Both fixes I will need a welder, etc. So it will have to wait for a bit.
this is the day I brought it home.

with wheels.

put new shocks on.

new mounting plates for the struts.

and now reworked rear brackets.


If it is not raining tomorrow, I will have some better pics.
The tires are sitting on the fender wells, so until I can strip out the back of the car and tub them this is how it is going to sit. Withe the 16s on the front frame braces drag the ground so it is as low as it is going to go for now as well, until I can notch the frame.
Both fixes I will need a welder, etc. So it will have to wait for a bit.
this is the day I brought it home.

with wheels.

put new shocks on.

new mounting plates for the struts.

and now reworked rear brackets.


If it is not raining tomorrow, I will have some better pics.
Thread Starter
Senior Member




SL Member
Scion Evolution
Joined: Jun 2004
Posts: 2,726
From: Over there
Originally Posted by 365Motorwerks
Done deal, now make a big scrape plate and start shaving reflectors off the road!
Thanx guys, this is by far not the end, ha ha. I plan to 4 link it and redo the front in the future as well. And figure out how to stay this low with 15x8 zero offset wheels,
I know my mom is happy with it too.
Thread Starter
Senior Member




SL Member
Scion Evolution
Joined: Jun 2004
Posts: 2,726
From: Over there
Originally Posted by Box_Rod
Hey goth...DOA is looking good. But I don't think your going to be happy until it's under the pavement by about 1 inch 










