anyone have one on their box?
preferably a PW box

since i took the emblems off the back i think it needs something back there.
the cf trunk handle looks dope!

any info on one would be appreciated as well!

thanks!

 

Well, here's one on my TCM xB, and its not the production piece, but the prototype cf trunk handle from Steve.

 

how does it fit on?
like remove the old piece and put this one on, or is it liek an overlay?

and you can get them right?

by the way, nice looking box

 

Mosh, they install by removing the OEM handle and replacing it w/ the cf one. You have to remove the fibreboard cover on the inside to access it.

I don't have any in stock right now.

 

Oh, and THANKS for the props.

Any questions, just ask.

 

nice tails squirrel

 

Where did you get those tails from??

 

Those are the OEM tails w/ the red cup and reflector removed. Just add red bulbs for the brake lights and its all good. I also have the yellow PIAAs for the turn signals and some brighter clears for back-ups.

 

Nice job done on the tail, pretty hard to unseal heh?

Eric

 

It sucks until you figure out how. I ruined a pair, then the second pair took me around a minute to unseal.

 

That's a sweet ride you have there squirrel. What's the drop you're pushing there? (getting tanabe df210s)

 

Evildave helped me do the tailights, he had them both done in less than 5 minutes.

I have a custom TEIN Wagon set-up. They were originally TEIN spec Wagons, but are now on my own spec rate and height springs. I can still go an inch lower than what you see.

 

Very nice drop for sure. Thanks for the info.

 

You're welcome! Any questions, just ask.

 

Oh alright.
When you get some in, give me a PM.
Thanks man.

 

I'll check w/ Steve and se what the production projection is looking like, and let you know.

Keep up the good work!

 

hey, this is available at FUJIZ if you are still looking for it...it is the bBist product, here is a link----> http://tinyurl.com/76rfs

 

Whats the shipping to 11782 on that cost?

 

chek pm

 

How are the fitments for these? Do they fit just like the OEM handle? Does it rattle? I'm very interested in this.