OK my dad is gettin these for me for Christmas and the only ones I can find are 40mm offset. Can anyone plz tell me what this means...I would like for them to sit flush with the fender well and my xB is not dropped at all so I don't think they will rub, I saw the SportMax 002 are 0 offset...plz someone tell me what I need. I don't mind using the 002, I just really don't want them inside the fenderwell like my steelies. Thank you so much xbHeads

 

Look for the 'mother of all sportmax 002' threads a few messages down.

 

says nothing about 40 offset

 

Sorry sounded like you were asking about the 002's these will stick out and will not be flush with the fenders. The 40 series will sit pretty flush, not sure if you saw the TRDs at the dealer but I believe those are 42 offset

 

The 40 offset will have a tucked in look It definitely will not sit flush with the fenders. The higher the offset the more tucked in it sits.

 

well they are ordered, so sh*t. is there any way i can use spacers or something to make them poke out a little bit more

 

If you run this in the rear it will sit pretty even with the front.
http://www.onetongarage.com/products...him/index.html.

I do believe this is what your looking for. You might be able to push it out farther but someone else will have to help out on that.

 

I run the DR16s on m xA with a ET40 offset and the OTG 10mm hub spacers in the rear.

On the xB they should sit just under flush.