The 42 offset is what worries me WILL IT WORK on a 205/45/17 falken 512

it wont be dropped with exception to the 1/2 inch with the monroe front struts

these are the wheels


THANKS

 

Anyone? will this work without rubbing
or
does anyone have pics

 

i have 215/40/18's on a 7" rim et42. no rubbing and im lowered. shouldnt be a problem.

but why not run a 215/45/17?

 

I'd be amazed if they rubbed

 

yea i dont think you will have any problems with them rubbing

 

thanks everyone

larry bird; the reason is that after much much research, I know 215/40 are much closer to stock rollng diameter and add more section width and better grip though at the cost of loss of traction in rain (read on some post here) or if going to big bear mountain; snow. Plus 205 are almost a pound lighter per wheel

the only thing I worry about is the 42 offset

 

I had 215/35 18s and 18x7 +45 wheels and they just barely grazed the one weld on the trailing arm on the right side, so with 3 less mm of offset it shouldn't rub

 

go to enkei.com and you'll see my car modeling the RSV's