best buys says they have a kit that will fit the tc, allow you to use a flip screen HU and still allow the cover to close properly. anyone seen an install like that before? if so post pics please. want to get a setup going but i cant sem to get 2 of the same answers from any of the places i went. all help welcomed and thanked.

 

cut the door
or take it off
thats about it really.

 

dang you got GOT!!!!

 

no they said they could order it and i would take 3 days, but they say it will do the trick

 

It just requires you drilling the holes a little further back than is provided.

 

you could angle it slightly and assuming your flip out goes out far enough...
if you drill the hole right so that its angled slightly and recesed itll fot
....itll just be ugly.

 

if you drill holes in the brackets you can fit anything, I had to drop my Kenwood DDX-7017 back like a 1/4 inch, but the door closes and opens fine

 

thanx, nice pics. i was thinking about going that route. what kind of kit you need for that and where can i get it?

 

its not a kit, just the stock brackets modified, all you need is a power drill and drill some holes further back on the bracket