I haven't seen any dyno's on this site yet, have i been browsing the wrong section? What do we put to the wheels?

 

roughly 137whp stock 5spd MT

 

I wonder if the 07 tC's make any more WHP.

 

I doubt it, if it did, they would have added it to the flywheel hp for better marketing.

 

well, they actually did. 1 more BHP. However, 06 used old SAE rating while 07 uses new SAE rating.

 

One of the magazines that are doing a tC project...not sure though, they baselined the tC at 143whp stock! pretty impressive seeings that the claimed crank hp is 165. It also depends on the weather though so it will differ

 

dynos are all over the site. Search harder.

The average is between 138-142, depending on weather conditions / oil change status / type of dyno / operator calibration, etc.

Full basic boltons (I/H/E/Spipe/Pulley/midpipe) nets between 158-162whp, depending on same factors.

Stock 1/4 - 15.6-15.8 @ 87-88
bolton 1/4 - 14.8-15.0 @ 91-92

You'll have some deviation, but this is a general idea.