tC: SOLD!!!
I have for sale some very rare Convex mirrors made for the 1st gen tc and 06+ Xa
they were one of my favorite mods and it seriously sucks going back to stock mirrors, all oem mirrors should come this way!
they are used, but might as well be new, no scratches, chips, discoloration etc etc
100% pure awesomeness!!
here are some pics of them on my kitchen counter!


you can google to see installed pics as i dont have any, however, they stand out since they have a blue tint and the driver is convex (magnified just like the passenger) basically everything looks a little smaller but increases the view area, eliminates blind spots almost entirely!!
because of the perfect condition, im asking what i paid for them
$70.00 SHIPPED
pm me if you want them
they were one of my favorite mods and it seriously sucks going back to stock mirrors, all oem mirrors should come this way!
they are used, but might as well be new, no scratches, chips, discoloration etc etc
100% pure awesomeness!!
here are some pics of them on my kitchen counter!


you can google to see installed pics as i dont have any, however, they stand out since they have a blue tint and the driver is convex (magnified just like the passenger) basically everything looks a little smaller but increases the view area, eliminates blind spots almost entirely!!
because of the perfect condition, im asking what i paid for them
$70.00 SHIPPED
pm me if you want them
Last edited by chicotunner07; Jun 7, 2012 at 10:31 PM.
Just put a set of these on the car and wondered why I ever let these sit for a year! All I think I would need to complete the look is a blue tint convex broadway mirror, thinking of 300mm. It takes a moment to adjust as mentioned but then all is good. I installed them replacing the OEM mirrors, didn't add any silicone to fill the gaps though as in TweakedIce's DIY. Did the mirror stick out a bit around the edge on the driver's side since it's not designed for a convex mirror? I ended up using a bead of sealer I got from the Nissan dealer(it's a long bead rolled up, just cut what you need, and it's some sticky stuff) and tucked that around the edge to seal it in.
Thread
Thread Starter
Forum
Replies
Last Post
rain7905643
PPC: Engine / Drivetrain
3
Jun 13, 2018 05:29 AM






