tC: Custom CNC Milled 'SCION' False Floor
Thread Starter
Joined: May 2005
Posts: 779
From: Stone Mountain, GA
I'm selling my false floor.
This piece was CNC milled out of 1/2" MDF and is precision cut to fit the rear floor of a first gen tC.
I got the idea from the xB guys who do this on their interior hatch trim. This is one of my favorite show pieces!
It's currently wrapped in Burgundy suede (I own a BCP tC). This can easily be removed and re-wrapped in leather, suede, or vinyl (CF Vinyl would be SICK)
There are 3 separate pieces (easier to remove). FITMENT IS PERFECT!! This piece is flat and can be covered by your trunk carpet for security. Again, it's completely removable, not screwing, glueing, etc. Just drop in and ride.
The raised 'SCION' logo was not glued, the entire piece was milled, then cut into 3. You can still use this with a sub box. I had the letters cut low enough on the board so a sub box could sit 'above' it and still display the logo. I had 2 JL 10s on top of this, no problem.
All 3 pieces together weigh about 20-25 lbs....it's all MDF.
Pics below.


Example of letters:

This is a one-off piece, and a show stopper!
I'm only asking $175 shipped. $140 picked up.
This piece was CNC milled out of 1/2" MDF and is precision cut to fit the rear floor of a first gen tC.
I got the idea from the xB guys who do this on their interior hatch trim. This is one of my favorite show pieces!
It's currently wrapped in Burgundy suede (I own a BCP tC). This can easily be removed and re-wrapped in leather, suede, or vinyl (CF Vinyl would be SICK)
There are 3 separate pieces (easier to remove). FITMENT IS PERFECT!! This piece is flat and can be covered by your trunk carpet for security. Again, it's completely removable, not screwing, glueing, etc. Just drop in and ride.
The raised 'SCION' logo was not glued, the entire piece was milled, then cut into 3. You can still use this with a sub box. I had the letters cut low enough on the board so a sub box could sit 'above' it and still display the logo. I had 2 JL 10s on top of this, no problem.
All 3 pieces together weigh about 20-25 lbs....it's all MDF.
Pics below.


Example of letters:

This is a one-off piece, and a show stopper!
I'm only asking $175 shipped. $140 picked up.
Thread Starter
Joined: May 2005
Posts: 779
From: Stone Mountain, GA
Price drop BUMP!
$150 Shipped...$125 picked up
I'm open to offers.
I'll take trades as well.
-Component Set
-Overhead Monitor (10"+)
-Aftermarket Head Unit with iPod capabilities.
Let's make a deal!
$150 Shipped...$125 picked up
I'm open to offers.
I'll take trades as well.
-Component Set
-Overhead Monitor (10"+)
-Aftermarket Head Unit with iPod capabilities.
Let's make a deal!
Thread
Thread Starter
Forum
Replies
Last Post
CONCRETETC
PPC: Interior / Electronics
1
Feb 9, 2015 08:05 PM






