I have a couple extra sets of these spacer shims kicking around.

Use these shims to widen the rear track width 10mm per side to match the front width. Installs between the rear axle beam and the wheel bearing housing. Waterjet from 6061-T6 aluminum. As strong as the machined ones, but a whole lot cheaper. Hardware included.

fits Scion xA/xB $40 shipped, today only.
email randode@randode.com

http://randode.com/suspension/10mmshims.jpg

 

are these up there with the OTG shims ive heard about so many years ago? also, i have 15 x 6.5 rims would these be enough to flush" the rear tires?

Thanks,


SEN_

 

probably not unless they are 0 or less offset, it is just to get the rear to sit as far out as the fronts.