Slow day at work
Thread Starter
Senior Member
SL Member
Scinergy
Joined: Mar 2005
Posts: 700
From: Marietta, GA
Slow day at work
It was slow at work today so I decided to wrap something in Ultra suede.
I programmed the CNC router to cut a 1/4" thick sintra panel and planed
it down to 1/8" thick and leave the 1/8" thick letters proud. The trick was
to leave a 1/2 round slope up to the face of each letter so that the suede
would lay down smoothly. Then I stuck on the yellow suede. It sure makes
it easier to have a glue pot and table to work with. It came out pretty nice
I think. This one is a lot quieter than the mirror panel which rattled. Now I
need to do the headliner.
New look
Old look
I programmed the CNC router to cut a 1/4" thick sintra panel and planed
it down to 1/8" thick and leave the 1/8" thick letters proud. The trick was
to leave a 1/2 round slope up to the face of each letter so that the suede
would lay down smoothly. Then I stuck on the yellow suede. It sure makes
it easier to have a glue pot and table to work with. It came out pretty nice
I think. This one is a lot quieter than the mirror panel which rattled. Now I
need to do the headliner.
New look
Old look
Senior Member
Team Scionce
SL Member
Joined: Aug 2007
Posts: 728
From: Rex, GA
Wow...that does look -really- nice. When I get bored at work I just end up playin' a prank on the crew like pouring flour on the guy coming out of the shower.
Fire Department Humor FTW!
Fire Department Humor FTW!
Thread
Thread Starter
Forum
Replies
Last Post
CombatmedicR56
Scion xA/xB 1st-Gen Drivetrain & Power
1
Nov 12, 2020 01:53 AM
cid_mcdp
Maintenance & Car Care
4
Jan 5, 2015 02:45 PM
