Is there anyone here that would be willing to cut out the S C I O N part of the front emblem for the tC? I tried, and i messed it up. Has anyone done this before? I know its been done for the rear emblem. I want to light it up!

 

You can try drilling small holes to fit fiber optic wire in it to make the effect you need. That way there is a easy way to fill it in if you mess up.

 

Use a very small cutting bit for the dremel and take your time....it is the bit that has the cutting ball at the tip.......about 3 hours to do it right at worst..........use a flexable tip for the dremel so you are not having to hold the dremel and cut.

 

I'm the one that did the emblem for the rear. I used the drill bit used for cutting holes in dry wall. I tried using the bit that has the cutting ball on the top, but I was to big. The drill bit is very small. About the thickness of a dime. Just take your time, Thats one of the problems I ran into on the first emblem, when I tried to rush throw. If you screw up you can always buy another emblem and try again and again

 

Your my idol for this project!