the 2 silver plastic piece's on the steering wheel i wanted to paint them black like the rest of my interior but i couldint get them off and can't find any diy on here help any one?

 

You need to take out the two torx screws on each side of the steering wheel, pull out the air bag, and then you will see the screws for the plastic pieces.

 

lol @ title

 

Ha. Was thinking the saaame thing.

 

Title was the reason I looked.. made me wonder what it was haha

 

great title...and yea you have to take off the 2 torx screws on the 2 sides of the steering wheel, take the airbag out and then... you will see the screws that is holding them on...

 

***disconnect battery for ten minutes before taking air bag out***

 

Very good note. I'm assuming it deploys?

 

you dont need to disconnect anything to remove the silver pieces.

You can leave the air bag plug in, same with the battery.

 

yeah... after you loosen the torx screws.. just pull the airbag out... no need to disconnect the airbag..

thus, no need to disconnect the battery.

get some wire cutters or something small to cut the ziptie holding the radio control plug in
(after you loosen the one big screw there and slowly wiggle the thing straight out)

the other side is just a screw holding it in.

 

you just have to jerk it more...

 

that's dirty

 

lol i knew some one was going to say something about the title lol thx alot

 

yea but dont twist it too much cus then it will break and it might explode

 

Fixed it for you Dave lol

 

you dont have to unplug the battery but its a good idea if only because you are going to be pressing on the horn while prying off the front panel.

 

...

you aren't gonna be pressing on the horn... i never do... even when putting the airbag back to screw in.

by accident though? possibly...