How to Install an emblem onto the trunk?
I plan to buy TRD or VVT-i emblem, but how do you glue it on? Do I need to drill holes? If glue, where can I buy that kind of glue for emblem? Thanks
not sure which vehicle you are talking about.
For the xB, the front emblem is simply clipped to the front grill. reach behind the grill and squeeze the clips.
Rear emblems are emblem taped on. Mine have a life span of about 400 more miles. I told myself I wouldn't do any body mods for 1000 miles. 377 to go, the emblems get shaved, along with a few other things I have on my mind.
For the xB, the front emblem is simply clipped to the front grill. reach behind the grill and squeeze the clips.
Rear emblems are emblem taped on. Mine have a life span of about 400 more miles. I told myself I wouldn't do any body mods for 1000 miles. 377 to go, the emblems get shaved, along with a few other things I have on my mind.
Originally Posted by jmiller20874
Originally Posted by itstdt
is there any more secure ways to put emblems on?
That's held on with the 3M sticky tape that came on the back of it.
You can also buy Trim and Emblem adhesive at your local auto parts store.
It's always a good idea to make a run to your local auto parts store to check out what they stock, before you start messing around with your ride.
Thread
Thread Starter
Forum
Replies
Last Post
killahXB2
Scion xB 2nd-Gen Aero & Exterior
4
Mar 29, 2016 04:22 AM
TheRedBox
Scion xA/xB 1st-Gen Drivetrain & Power
31
Dec 2, 2003 04:53 PM









